在全自動砂漿水泥挍拌車的正常運行過程中，如果氣路系統經常出現問題，其運行功率會線性下降，甚至無法正常啟動的現象也很嚴重。

In the normal operation process of the automatic mortar cement mixer, if the air system often has problems, its operation power will decline linearly, and even can not start normally.

1.全自動砂漿水泥挍拌車的空壓機應水平放置，固定并通風。

1. The air compressor of automatic mortar cement mixer should be placed horizontally, fixed and ventilated.

2.無法承受風吹雨打，也不能暴露在陽光下。

2. Can't bear the wind and rain, and can't be exposed to the sun.

3.調整氣壓自動開關的上限和下限。如果壓力太低，則氣缸會減速，如果壓力太高，則氣動系統的密封件會很不幸。

3. Adjust the upper and lower limits of the air pressure automatic switch. If the pressure is too low, the cylinder will slow down. If the pressure is too high, the seals of the pneumatic system will be very unfortunate.

4.檢查全自動砂漿水泥挍拌車的潤滑油油位，并堅持使油位在量油尺的上，下線之間。當油位接近下線時，添加新油。

4. Check the lubricating oil level of the automatic mortar cement mixing truck, and keep the oil level between the upper and lower lines of the dipstick. When the oil level is near the end of the line, add new oil.

5.檢查傳送帶的張力是否合適。用手指按壓皮帶時，皮帶應下垂約10mm。更換傳送帶時，應更換整個組以保持共同的張力。

5. Check whether the tension of the conveyor belt is appropriate. When pressing the belt with fingers, the belt should sag about 10 mm. When replacing the conveyor belt, the whole group should be replaced to maintain the common tension.

6.氣體系統必須充滿令人滿意的機油，并堅持令人滿意的機油量和令人滿意的正常運行。只有這樣，前混合器的功率才能一起使用，以延長氣體系統的使用壽命。

6. The gas system must be filled with satisfactory oil, and adhere to satisfactory oil quantity and satisfactory normal operation. Only in this way can the power of the front mixer be used together to extend the service life of the gas system.

今日自動上料混凝土攪拌車的精彩內容就給大家分享到這了，更多的精彩內容請點擊我們的網站http://www.ranhaofz.cn留言，或者直接撥打電話詢問，我們會有專門的人員為您服務.

Today's auto feeding concrete mixer's wonderful content will be shared with you. For more wonderful content, please click our website http://www.ranhaofz.cn Leave a message, or call directly, we will have special staff to serve you