Method for cleaning soil slag by concrete mixer:

混凝土攪拌車這種機械設備在長時間的使用中不免會存在故障的發生，這時就需要我們對機械土渣進行清理工作。那么接下來讓我們詳細了解一下關于設備正確清理土渣的方法吧。

The mechanical equipment such as concrete mixer will inevitably have faults in long-term use. At this time, we need to clean up the mechanical soil residue. Then let's learn more about the method of correctly cleaning soil residue by equipment.

1、準備好緊急驅動軟管，將小型混凝土攪拌車熄火，卸下液壓馬達上的高壓油管接頭。

1. Prepare the emergency drive hose, shut down the small concrete mixer, and remove the high-pressure oil pipe connector on the hydraulic motor.

2、將救援車熄火，將其液壓馬達的高壓油管卸下，并與故障車上的對應接頭用緊急驅動軟管相連。

2. Turn off the rescue vehicle, remove the high-pressure oil pipe of its hydraulic motor and connect it with the corresponding connector on the faulty vehicle with emergency drive hose.

3、發動救援車，將其操縱手柄撥至出料位置，故障車內的混凝土即被排出。

3. Start the rescue vehicle and turn its control handle to the discharge position, and the concrete in the faulty vehicle will be discharged.

4、緊急驅動完畢后，將驅動軟管卸下，并恢復兩車原狀。

4. After the emergency drive, remove the drive hose and restore the two vehicles to their original state.

5、在托輪和滾道之間放入木楔，以控制攪拌筒的旋轉，一定要注意周圍不要發生危險；將發動機熄火，拆松液壓馬達的一根高壓油管，攪拌筒可自由旋轉。

5. Put a wooden wedge between the supporting wheel and the raceway to control the rotation of the mixing drum. Be sure to pay attention to avoid danger around; Turn off the engine, loosen a high-pressure oil pipe of the hydraulic motor, and the mixing drum can rotate freely.

6、控制攪拌筒的旋轉，使維修孔轉到下部，然后打開維修孔，清理出筒內混凝土。混凝土排出完畢后，恢復小型混凝土攪拌車原狀。

6. Control the rotation of the mixing drum to turn the maintenance hole to the lower part, and then open the maintenance hole to clean out the concrete in the drum. After the concrete is discharged, restore the small concrete mixer to its original state.

在正常情況下，合理的清理混凝土攪拌車使用中所出現的土渣，能夠很好的保證設備在使用中的良好操作性能。同時在實際施工操作中，還需要我們對設備的運行多加關注才行，也能夠很好的避免一些不必要的故障發生。

Under normal circumstances, reasonably cleaning the soil slag in the use of concrete mixer can well ensure the good operation performance of the equipment in use. At the same time, in the actual construction operation, we also need to pay more attention to the operation of the equipment, which can also well avoid some unnecessary faults.