Hello everyone, I'm a small editor of the automatic feeding mixer. Recently, the small editor has learned some latest industry related knowledge, and I'm here to share with you today.

　　如果不能在混凝土預凝之前將車輛修復，應立即采取應急措施：

　　If the vehicle cannot be repaired before the concrete pre setting, emergency measures shall be taken immediately:

　　1、自動上料混凝土攪拌車的馬達和減速機無故障情況下，連接“應急油管”將混凝土卸出，預防凝灌事故發生。

　　1. When the motor and reducer of the automatic loading mixer have no fault, connect the "emergency oil pipe" to unload the concrete, so as to prevent the occurrence of concreting accident.

　　2、自動上料混凝土攪拌車的馬達或減速機發生故障且確定無法在混凝土預凝前使罐體轉動，請快速打開人孔蓋，如人孔蓋不在罐體下方則需要在罐體前錐底部開孔（Φ=1250px，避開原有焊道），與此同時必須持續向進料口灌入大量清水，沖刷罐內混凝土，直至罐體下方無混凝土流出，罐內少量殘余混凝土需人工進行清理，清理完畢后進行清洗，將割下部分重新焊接到罐體上（安裝人孔蓋），并打磨噴漆處理。

　　2. If the motor or reducer of the automatic feeding mixer fails and it is determined that the tank can not rotate before the concrete is pre set, please quickly open the manhole cover. If the manhole cover is not below the tank, it is necessary to open the hole at the bottom of the front cone of the tank (Φ = 1250px, avoiding the original weld pass). At the same time, a large amount of clear water must be continuously poured into the feed inlet to wash the concrete in the tank until there is no concrete under the tank When the concrete flows out, a small amount of residual concrete in the tank needs to be cleaned manually. After cleaning, clean it, weld the cut part to the tank body (install the manhole cover), and polish and spray paint.

　　以上就是自動上料混凝土攪拌車的小編為大家帶來的知識，希望能對您起到幫助。

　　The above is the knowledge brought to you by the small part of the automatic feeding mixer. I hope it can help you.