After using the automatic concrete feeding mixer for a period of time, we often encounter the blockage of the feeding port. Today, we will teach you how to deal with the blockage of the feeding port?

1．在每天收工時將混凝土貯罐及進出料口周圍徹底清洗，自動上料攪拌車的清洗要點保證不粘有水泥及混凝土結塊；注意在每次裝料前都要用水沖洗進料口，這樣可以使使進料口在裝料時保持濕潤。

1. Thoroughly clean the concrete storage tank and the area around the inlet and outlet at the end of each day. The key points for cleaning the automatic feeding mixer truck shall ensure that there is no cement and concrete caking; Note that the feed inlet shall be flushed with water before each loading, so as to keep the feed inlet wet during loading.

2．在裝料的同時將隨車自帶的清洗用水水箱中注滿水；在裝料后沖洗進料口，洗凈進料口附近殘留的混凝土；到工地卸料后，沖洗出料槽，然后向混凝土貯罐內加清洗用水30—40 L；在車輛回程時保持混凝土貯罐正向慢速轉動；下次裝料前切記放掉混凝土貯罐內的污水。

2. While loading, fill the water tank with water for cleaning that is provided with the vehicle; Flush the feed inlet after loading, and clean the residual concrete near the feed inlet; After unloading at the construction site, flush the discharge chute, and then add 30-40 L of cleaning water to the concrete storage tank; Keep the concrete tank rotating slowly in the forward direction during the vehicle return; Remember to drain the sewage in the concrete storage tank before the next loading.

3.自動上料攪拌車進料口給料量是否合理：正確的方式是物料在吸料口和空氣形成一定的氣物混合比，在氣流的推動下均勻流入上料機。這個時候我們需要將料槍設計帶有補氣功能。如果物料積壓時間過長可能很硬，這個時候需要在料槍上裝一個振蕩器，敲碎結塊的物料。

3. Whether the feeding amount at the feeding port of the automatic feeding mixer is reasonable: the correct way is to form a certain mixture ratio of air and material at the suction port, and the material will flow into the feeder evenly under the promotion of the air flow. At this time, we need to design the charging gun with the air supplement function. If the material is overstocked for a long time, it may be very hard. At this time, an oscillator needs to be installed on the material gun to break the caked material.

以上就是為大家介紹的有關全自動自上料攪拌車詳細的介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以的態度,為您提供服務http://www.ranhaofz.cn/

The above is a detailed introduction to the fully automatic self loading mixer, and I hope it will be helpful to you. If you have any questions, please contact us. We will provide you with our attitude http://www.ranhaofz.cn/